Mitutoyo ABSOLUTE Digimatic Indicator ID-C, Series 543 Calculation Type - 543-598BBrand: Mitutoyo
|Range||2" / 50.8mm|
|Measuring Force||2.3N or less|
Mitutoyo ABSOLUTE Digimatic Indicator ID-C, Series 543 Calculation Type
- The new Calculation-Type Digimatic Indicator features both a Key- Lock and Parameter-Lock. This is designed to prevent accidental changing of settings during operation.
- Improved parameter setting software makes it even easier to set all of the available parameters and determine and upload the proper coefficients for calculation.
- FAST measurement frequency allows the user to increase the number of readings per second from 10 to 50, allowing higher accuracy meaurements of TIR and MAX/MIN.
- An analog bar provides easy to read values when scanning for Max, Min, and TIR Values.
- The Absolute Digimatic indicator performs internal calculations using the formula Ax+B+Cx-1 (assuming spindle displacement as x) while the specified coefficients A, B and, C can be set with respect to the purpose of measurement or dimensions of the fixtures. This unique features allows you to read your measurements directly, without fumbling for conversions.
- Accuracy: Refer to the list of specifications below
- Resolution: 12 Steps
- Display: LCD
- Length standard: ABSOLUTE electrostatic capacitance type linear encoder
- Max. response speed: Unlimited
- Measuring force: Refer to the list of specifications below
- Battery: CR2032 (1 pc.), 05SAA217
- Battery life: Approx. 12 months under normal use
- IP Rating: Equivalent to IP-42*1
*1 A protection class indication (IP=lnternational Protection) is based on the IEC 60529 /DIN40050 part 1/JIS D0207, C0920. The level indicated is valid only if the output connector cap is installed.
- Key Lock
- Parameter Lock
- PC-USB Input
- Analog Bar
- FAST measurement frequency
- Preset (up to 3 values)
- Tolerance Judgment
- Peak Detection
- inch/mm conversion (on inch/metric models only)
- Counting direction switching
- Data Output
- Alarm: Low voltage, Counting value composition error, Over-flow error, Tolerance limit setting error
- 905338 - Connecting Cable (1m)
- 905409 - Connecting Cable (2m)
- 21EZA313 - USB cable and Outline of Parameter Setting Software
- 21EZA198 - Spindle lifting lever (12.7mm ISO/JIS type)
- 21EZA199 - Spindle lifting lever (12.7mm ASME/AGD type)
- 540774 - Spindle lifting cable
|METRIC - Stem ø 8mm, M2.5 x 0.45 Thread (ISO/JIS type)|
|Resolution||Order No.*||Range||Model||Accuracy||Measuring Force|
|543-598B||2" / 50.8mm||ID-C150RXB||0.006mm||2.3N or less|
* Flat Back