GS Tooling HSK63A Metric Shrink Fit Holders w/ Coolant Ports
- Unsurpassed Accuracy: Concentricity of ≤.0001” (3μm) with tool shrunk in holder.
- Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool.
- Max Gripping Torque: Tool is gripped 360° along the entire length of bore producing very high gripping torque, preventing chatter.
- Increased Production: Decrease down time - the total time elapsed to remove one cutting tool and insert another is less than 10 seconds.
- Balanced: GS follows the strictest balance standards. Our holders are pre-balanced G2.5 up to 30,000rpm
- Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder.
- Chip load distributed evenly along cutting edge of tool which results in longer tool life
- Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending.
- Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.
Item No. | D1 | A | D2 | D3 | L |
546-300 | 3mm | 80mm | 15mm | 20mm | 9mm |
546-302 | 4mm | 80mm | 15mm | 20mm | 12mm |
546-304 | 5mm | 80mm | 15mm | 20mm | 15mm |
546-306 | 6mm | 80mm | 21mm | 27mm | 36mm |
546-308 | 6mm | 160mm | 21mm | 27mm | 36mm |
546-310 | 8mm | 80mm | 21mm | 27mm | 36mm |
546-314 | 10mm | 85mm | 24mm | 32mm | 42mm |
546-318 | 12mm | 90mm | 24mm | 32mm | 47mm |
546-322 | 16mm | 95mm | 27mm | 34mm | 50mm |
546-326 | 20mm | 100mm | 33mm | 42mm | 52mm |
546-330 | 25mm | 115mm | 44mm | 53mm | 58mm |
546-334 | 32mm | 120mm | 44mm | 53mm | 58mm |
For more info, visit www.p65warnings.ca.gov.