Hossfeld H60 L-Frame Hydraulic Package - 49401Brand: Hossfeld
Hossfeld H60 L-Frame Hydraulic Package - 49401
Includes everything in the Standard package plus the "L-Type" Swinging Frame for bending 180º with wraparound Tube and Pipe Dies. L-Frame switches easily with Standard Swinging Frame using a single pin.
- H60 Hydraulic Pump with Hoses and Foot Switch
- H4 Hydraulic Cylinder Ass'y
- Hydraulic Hardware Conversion Kit
- H52 "L-Type" Swinging Frame
No. 2 Bender with attached L-Type Swinging Frame (shown in red) for bending Tube and Pipe to 180°
H60 Hydraulic Pump
- Modular design using industry standard components
- Quieter and more efficient
- State-of-the-art pressure-balanced gear pump provides greater efficiency and quiet operation.
- Comes standard with stroke limit switch for precision bending
- Redesigned foot switch with foot guard large enough for steel-toed boots
- 10-ft cord lets you place foot switch where it's most convenient
Bending heavy stock is even easier with the fully-redesigned H60 Hydraulic Pump – the only hydraulic unit you'll ever need for the Model No. 2 Bender. All-hydraulic pump is faster than air-over-hydraulic — 1000 psi bends 2" Pipe in under 2 minutes, depending on operator skill.
- 1000 PSI – bend just as fast using less force
- FAST! Pumps 453 cu. in. of oil per minute
- Operates on 15 amp circuit
- Stroke limit switch attaches to bender circle for repeat bends
- All-new foot switch with OSHA-approved foot guard
- Separate extend/retract pedals
- Foot switch and 10-foot cord accommodates your shop arrangement, and gives you hand-free control
- Liquid-filled pressure gauge for easy pressure reading
- Large adjustment knob for easy pressure control, even with gloves on
- 1-1/4" – 2" OD Tube
- 1" – 2" Sched. 40 Pipe
- 1-1/2" x 1-1/2" x 1/8" through 2" x 2" x 3/16" Angle Iron
- 3/4" –1-1/4" Round or Square Bar
- Rectangular Tube up to 1" x 2"
- Edgebend Flat stock up to 1/2" thick
Click to see the: