Rushmore 2 Flute Micrograin Solid Carbide Single End Mills
Square-Nose Single End Mills for Use on Ferrous & Non-Ferrous Workpieces.
These straight shank single-end mills are offered with a two-flute spiral design with a lower 30-degree helix angle.
It goes on to improve machining stability at high speeds.
The center-cutting design has cutting teeth at the end of the tool, thus fed into the workpiece like a drill bit.
Shank diameter tolerance is -0.0000 inch to -0.0005 inch.
Helix Angle: 0°
Center Cutting: Yes
Cutting Direction: Right Hand
Workpiece Material Range: Steel, Stainless Steel, High-Temp Exotic Alloys, Non-Ferrous, Cast Iron, Hard Materials, Plastics
WARNING: This Product Can Expose You To Materials And/Or Chemicals Which Are Known To The State Of California To Cause Cancer And/Or Reproductive Harm.
