T&O 4 Flute SuperCEED® Solid Carbide Coated Finishing Single End Mills
Brand: T&O- ID:
- 679154
T&O 4 Flute SuperCEED® Solid Carbide Coated Finishing Single End Mills
- Restricted heat conductivity.
- Increased cutting speed.
- Chip Formation Improved
- Lower friction, higher flow speed.
- Reduced chip compression/cutting forces.
- Extension Of Tool Performance
- High hardness protects against abrasive wear.
- High chemical stability prevents built-up edge, micro cracks and crater wear.
- Increase in tool life.
- Center Cutting
- Cutting Direction: Right Hand
- Helix Angle: 30°
- Tolerance_Cutting Diameter: -.0005" / -.0015"
- Tolerance_Shank Diameter: -.0001" / -.0005"
- Workpiece Material Range: Steel, Stainless Steel, High-Temp Exotic Alloys, Cast Iron, Hard Materials
TiN (Titanium Nitride)
- TiN treatment will provide heat resistance and extreme hardness to allow the tool to run at higher feeds and speeds.
- TiN allows higher lubricity for freer chip flow, reducing build-up edge formation and cratering - great for general purpose use.
- On non-ferrous materials there is a tendency to gall so please use caution.
- TiN also requires an increase of 25% to 30% in machining speeds vs. uncoated tools.
TiCN (Titanium Carbonitride)
- When under conditions of moderate cutting temperatures, TiCN is harder and more wear resistant than TiN.
- It also provides 50% more spindle speed compared to TiN, especially in stainless steels.
- There is a tendency to gall on non-ferrous materials so please use caution.
- TiCN also requires an increase of 35% to 50% in machining speeds vs. uncoated tools.
For more info, visit www.p65warnings.ca.gov.